–
Thrust-Vectoring EDF Rocket
Team project · Mechanical design, electronics, and controls
Built with two teammates, this electric ducted-fan rocket uses an 80 mm EDF and four servo-actuated flaps for thrust vector control. An ESP32 runs a PID controller that uses MPU feedback to calculate corrective flap movement.
Project overview
A three-person build to see how well an electric ducted fan could be steered and stabilized with thrust vector control. Four flaps sit in the fan exhaust, and the ESP32 moves them to keep the rocket upright.
My contribution
I CAD-designed and 3D-printed the complete rocket structure, managed the electronic wiring, design, and packaging, and developed the PID control algorithm. I also created a digital testing interface to simulate rocket orientation and thrust-vector-control responses, and supported the team’s tethered testing.
Design and electronics
The 3D-printed structure houses an 80 mm electric ducted fan and four servo-actuated TVC flaps. The electronics are built around an ESP32, with wiring and packaging integrated into the rocket structure.
Stabilization and controls
The PID loop reads orientation from the MPU and converts the error into flap angles. Before running it on hardware, I used a digital testing interface to simulate the rocket's orientation and check how the flaps would respond.
Specifications
- Propulsion
- 80 mm electric ducted fan
- Thrust vector control
- 4 servo-actuated flaps
- Controller
- ESP32
- Sensor feedback
- MPU
- Control algorithm
- PID
- Structure
- CAD-designed and 3D-printed
Testing
The rocket was tested on a tether so the PID gains could be tuned and the balance checked without risking a free flight.